Ultimate Skills

Ultimate Frisbee Backhand: How to Throw It

How to throw a backhand in ultimate frisbee: grip, reach-back, hip-led pull-through, flat release and follow-through, plus common mistakes and how to fix them.

On this page
  1. Grip: fan grip for touch, power grip for distance
  2. Set up with your body across the target
  3. The reach-back: straight, not looped
  4. The pull-through: hips lead, arm follows
  5. Release flat, with a wrist snap
  6. Follow-through and balance
  7. How the disc flies: turn and fade
  8. Common backhand mistakes and fixes
  9. A distance progression to practice

The backhand is usually the first throw most players learn, and many players rely on it more than any other. It is easy to release quickly, it’s reliable at short range, and with good form it can go a long way. The motion pulls the disc across your body and releases it on a flat line toward the target. This guide breaks it into steps and covers the mistakes that most often hold players back.

Grip: fan grip for touch, power grip for distance

Hold the disc as if you’re shaking hands with it: fingers under the rim, thumb on top. Two grips are common. A fan grip has your index finger under the rim and your other three fingers spread out below the disc. It gives you control and accuracy, so it’s a good everyday choice for short and medium throws. A power grip tucks all four fingers tightly under the rim. It helps you generate spin and distance, but usually costs some accuracy. Most players use a fan grip for most throws and switch to a power grip for pulls and long throws.

Rest your thumb on the top flight rings, angled forward. The best spot depends on your hand size, so try a few positions. Don’t put your index finger along the outside edge of the disc. It takes away power and can jam a finger on contact. Hold the disc firmly, but don’t clamp down so hard that your wrist can’t move.

Set up with your body across the target

Start with your body turned so your hips are roughly perpendicular to the target. Plant one foot, keep your knee bent for balance, and step out with the other if you want more power. When you’re learning, a standing throw is fine. Footwork adds power, but clean mechanics matter more first. Add steps once the motion is smooth.

The reach-back: straight, not looped

Reach the disc back in a straight line at about chest height, keeping the disc on the same plane as your arm. Pull back as far as you can while staying balanced. The most common error is rounding, where the disc swings wide in an arc around your body. Rounding takes the disc off your line and robs you of power. Think of the pull as a straight rail from the reach-back point across your chest to the release point, like starting a lawnmower.

The pull-through: hips lead, arm follows

The power in a backhand starts from the ground up. Your planted foot stops your rotation, your hips turn first, then your shoulders, then your elbow drives forward and your forearm extends. Your wrist snaps last. Hips-first timing is what matters. If your arm starts the throw while your lower body stays quiet, you’re “arming” the disc, which limits distance and can strain your shoulder. Film yourself from the side to check the order.

Release flat, with a wrist snap

Release the disc flat or nearly flat. A nose-up release makes the disc climb, lose speed and often turn over to the side. Snap your wrist at the end of the motion to add spin, which keeps the disc steadier in flight. Aim with your reach-back and pull, not by steering the disc with your hand at the last moment. Steering with your hand is a common cause of griplock, where the disc hangs on too long and veers hard.

Follow-through and balance

Let your throwing arm keep moving across your body after the release. Let your pivot foot turn as your weight moves forward, and finish balanced and facing the target. If you fall off balance after most throws, you’re probably throwing harder than your current form can handle. Back off until the motion is smooth and you can finish balanced, then build speed.

How the disc flies: turn and fade

Ultimate discs glide well, turn early when thrown hard, and fade back late. For a right-handed backhand, a hard throw usually turns right early, then fades left at the end of its flight. Lighter throws turn less and fade more. This is typical, not guaranteed, and it changes with power, angle and wind. The easiest way to learn it is to throw to the same spot at different powers and watch where the disc goes.

To counter a hard throw’s turn, many players release on an inside-out angle, tilting the disc so it starts on a line that turns back into a straight flight. For a lighter throw that you want to curve, an outside-in angle can work. Start with flat releases first, then add angles once the basic throw is steady.

Common backhand mistakes and fixes

  • Rounding. The disc swings in an arc instead of a straight line. Fix: slow the reach-back and pull the disc straight across your chest.
  • Griplock. The disc hangs on too long and veers hard. Fix: loosen your grip slightly and let the disc release at full extension.
  • Nose-up release. The disc climbs, stalls and dumps to the side. Fix: check your wrist angle at release and keep the disc flat.
  • Arming the throw. The shoulder does all the work while the hips stay still. Fix: start the throw with the hips and drill the order slowly.
  • Rushing the run-up. A hurried step ruins your timing. Fix: throw from a standstill until the motion feels automatic.
  • Losing balance. You fall or lurch after the throw. Fix: keep your pivot knee bent and practice stepping out and throwing under control.

A distance progression to practice

Practice the flat backhand at 5 yards until it’s steady, then 10 yards, then 20 and 30 yards. Move up only when the throw feels smooth and accurate. Once you can throw a consistent flat backhand at 10 to 15 yards, practice different release points: above your shoulder, low near the ground, and with your arm extended away from your body. These help you throw around a marker in a real game.

A good drill is to throw with a partner at each distance and call out the target before each throw. If the disc goes where you called, you’re ready for the next step. If it doesn’t, check your reach-back and release first.

For a throw that goes much farther, see the huck guide. The forehand grip and throw guide covers the other main throw. If your backhand keeps going wrong, the why am I so bad at throwing a frisbee guide lists the usual causes. The pillar guide shows where the backhand fits among the other basic skills.

The complete guide to ultimate skills

Ultimate Frisbee Basic Skills: Tips and Tricks for New Players
Read the guide

Keep exploring

Guides from other topics

All topics →