Disc Flight and Lines

What is a lie in disc golf?

A lie in disc golf is the spot where your last throw landed. Learn how to mark it, stand legally behind your marker, and handle the putting circle.

On this page
  1. Short answer
  2. Where your lie comes from
  3. Marking your lie
  4. Stance behind the marker
  5. Putting inside the circle
  6. When a lie changes: penalties
  7. Local rules and the PDGA rulebook
  8. Where to go next

Short answer

In disc golf, a lie is the spot where your previous throw came to rest, and the place you must stand to make your next throw. The tee area is the lie for your first throw on each hole. After that, your lie is wherever your disc last landed.

Where your lie comes from

Each hole starts at the tee. You throw your first shot from the tee pad, and where the disc lands becomes your lie. Your next throw starts from that lie, and this continues until the disc comes to rest in the basket.

This is the disc golf version of playing a ball where it lies in ball golf. You always throw from where the last disc stopped, so position matters as much as distance.

Marking your lie

Before you throw, mark your lie so everyone knows where you must stand. There are two common ways.

Leaving the disc in place

You can leave your disc where it landed and stand behind it. The disc itself acts as the marker, and your stance is taken directly behind its back edge.

Using a mini marker

If you want to pick up your disc, for example to throw it again or gain a few inches on a putt, place a mini marker disc on the ground touching the front edge of the thrown disc. The mini must sit on the line of play, which is the imaginary straight line from the target through your disc. Then pick up the thrown disc and stand behind the mini.

Stance behind the marker

When you throw, at least one supporting point, such as a foot, must be behind your marker at release. No supporting point can be closer to the basket than the marker. A foot that crosses the marker before the disc leaves your hand is a foot fault, and it can lead to a penalty.

The area for your supporting point is small and sits directly behind the marker. Its exact size is set in the PDGA rules, so check the current rulebook rather than relying on a rule of thumb.

Putting inside the circle

Inside the 10-metre circle around the basket (Circle 1 in PDGA terms), putting is stricter. After you release the putt, you cannot step or fall past your lie during the follow-through until the disc has come to rest or you have shown your balance. Outside that circle, you can run up and follow through more freely.

When a lie changes: penalties

Penalties can move you from your lie. Common examples include:

  • Out of bounds. The disc lands outside a marked boundary. You add a penalty throw and replay from a legal spot near where the disc left the course.
  • Missed mandatory. The disc goes the wrong side of a marked obstacle that it had to pass on a specific side. You take a penalty.
  • Lost disc. If the disc cannot be found in the time allowed, you add a penalty and replay from your previous lie.

Penalties vary by course and event, so check the course rules and the PDGA rulebook before you play.

Local rules and the PDGA rulebook

Casual rounds usually follow the course’s posted rules. Tournaments follow the PDGA rulebook. For exact lie measurements and optional rules, such as the 2-metre rule for a disc stuck above the ground, check the PDGA’s current official rules.

Where to go next

The complete guide to disc flight and lines

How Disc Golf Discs Fly: The Science of Flight
Read the guide

Keep exploring

Guides from other topics

All topics →