Backhand Technique

Disc Golf Backhand Throw: Step-by-Step Technique for Beginners

Learn the disc golf backhand step by step, from grip and stance through reach-back, pull-through, release and follow-through, plus fixes for common mistakes.

On this page
  1. What a right-handed backhand does
  2. Set your grip before anything else
  3. Stance and setup
  4. Learn the standstill version first
  5. The reach-back and straight pull
  6. The power pocket and hip rotation
  7. Release and nose angle
  8. Follow-through
  9. Common problems and quick fixes
  10. A practice progression
  11. Choose discs that fit the lesson
  12. Warm up and look after your elbow
  13. Practice that lasts
  14. Quick checklist

The backhand is the throw most disc golfers learn first. Once it is dependable, it gives the most distance and the widest range of shots. It also gets more advice than almost any other part of the game, and much of that advice contradicts itself. This guide puts the pieces in order: setup, the standstill version of the throw, the reach-back and pull, the power pocket and hip rotation, the release, and the follow-through. After that come the fixes most beginners need and a practice plan you can follow without a coach.

The steps below describe a right-handed backhand. Left-handers can mirror them; see our left-handed backhand guide.

What a right-handed backhand does

A right-handed backhand starts on the right side of your body, pulls across the front of your chest, and releases toward the target. A stable disc thrown this way usually starts slightly to the right of your line and finishes left. Understable discs turn right more before they fade. The flight numbers printed on each disc (speed, glide, turn and fade) describe how a disc is designed to behave, but you don’t need to memorize them before you start throwing.

Set your grip before anything else

Hold the disc with your fingers firm on the rim but not clenched, and your thumb on top with moderate pressure. Three grips come up most often: the power grip, the fan grip and a back-loaded grip. Pick one and practice it for a few weeks before you change it, because a new grip changes the whole throw. Grip details are in our backhand grip guide.

Stance and setup

Stand with your body sideways to the target. For a right-hander, the left foot is the front foot and points roughly along the target line. The right foot sits behind it, angled so your hips can turn. Keep your weight balanced over both feet with your knees slightly bent. Hold the disc at about chest height with your elbow comfortably bent. Don’t lock your knees, and don’t lean your shoulders toward the target before the throw starts.

Learn the standstill version first

Start without a run-up. A standstill throw shows the sequence in slow motion:

  1. Reach back along your target line while your weight moves to the back foot.
  2. Shift your weight forward and plant the front foot firmly.
  3. Turn your hips toward the target.
  4. Let your torso follow the hips.
  5. Lead the pull with your elbow, bringing the disc through the power pocket.
  6. Extend the arm and release off your fingers.
  7. Follow through along the line of the throw.

A standstill throw goes shorter than a full run-up, and that is fine. Repeatable standstill throws are the base for everything else. The footwork details, including the X-step, are in the footwork guide.

The reach-back and straight pull

Reach back along the line you want the disc to travel, not in a wide arc behind your body. That arc is called rounding. Rounding pulls the disc off line and costs power, because the disc is moving in a curve as you release it. On the pull, keep the disc close to the line you set and bring it across your chest toward the power pocket. The pull-through mechanics are covered in our pull-through and hip rotation guide.

A simple check: if your arm leaves an imaginary wall you could place along your target line, you are rounding.

The power pocket and hip rotation

Between the reach-back and the release sits the power pocket. The disc is close to your chest, your elbow is bent to roughly 90 degrees, and your body is coiled. From there the hips turn toward the target first, the torso follows, and the arm extends.

If the arm starts pulling before the hips have turned, the throw becomes an all-arm throw. Arm-only throws are one of the most common reasons beginners stop improving. Slow the throw down and let the legs and hips start the motion. The disc should speed up in the last part of the pull, not the first.

Release and nose angle

Release the disc off your fingers, with the front edge level or slightly down. A nose-up release makes the disc climb, stall and fade early, which is why many drives fall short even when they were thrown hard. Keep the grip firm without clenching, so the disc leaves your fingers rather than being pushed out by your palm. Release mechanics and spin are covered in our release technique guide.

Follow-through

Let the arm continue along the line of the throw after release. Your back foot pivots as your body turns through, and you finish balanced, facing roughly toward the target. Stopping the arm abruptly after release tends to pull the disc off line and makes timing harder to repeat.

Common problems and quick fixes

  • Nose up or high flight: lead the pull with your elbow instead of your hand, and check that the front edge is level or slightly down at release. More detail is in our throwing problems guide.
  • Wobble: look for a rolling wrist at release and a grip that changes from throw to throw. Keep the follow-through on the throwing line.
  • Rounding: reach back on a straight line. A wall, fence or a cone set on your target line gives you a visible reference.
  • Short, early-fading drives: check your timing first, then your disc speed. A disc that is too fast for your arm speed often stalls and fades.
  • All-arm throw: slow down to about 50 to 70 percent power and let the hips lead until the sequence feels normal.

A practice progression

  1. Standstill throws at 50 to 70 percent power. Work on one cue at a time, such as the straight pull.
  2. Add a single step or a short walk-up once the standstill throw repeats.
  3. Add the full X-step only when standstill throws are consistent.
  4. Add speed only when your flight stays consistent.

Film three throws from behind and three from the side. Watch them in slow motion, and compare them with a slow-motion video of an experienced player’s backhand. The side view is usually the one that shows the hip and elbow timing.

Choose discs that fit the lesson

Learn with a putter and a midrange. Both are easy to control and show your form clearly. Add a fairway driver once your backhand repeats. High-speed distance drivers can exaggerate form problems, and most beginners find them hard to control. For more on choosing discs and on adding distance safely, see how to throw a disc golf disc farther.

Warm up and look after your elbow

Warm up before you throw hard, and keep the first sessions gentle. A short routine before you play makes a noticeable difference to how the throw feels, and our warm-up guide gives one you can use. If your elbow hurts, stop throwing and get it checked. Our elbow pain guide explains when pain needs professional care.

Practice that lasts

Two short sessions a week tend to work better than one long session. Keep each session to a single focus, such as the straight pull or the release, and finish while your form still looks good. Structured backhand drills cover timing, accuracy and putting in a way you can track from week to week.

Quick checklist

  • Grip: firm on the rim, moderate thumb pressure, same grip every throw
  • Stance: sideways to the target, weight balanced, left foot forward for a right-hander
  • Reach-back: straight along the target line, no rounding
  • Pull: hips first, elbow leading, disc through the power pocket
  • Release: front edge level or slightly down, disc off the fingers
  • Follow-through: arm continues on the line, finish balanced

Keep exploring

Guides from other topics

All topics →