The pull-through is the part of the backhand where the arm brings the disc from the reach-back, across the chest, into the power pocket and on toward the release. It looks like the most arm-driven part of the throw. In a well-timed throw, though, the arm is responding to the hips. This article explains that order, what “elbow up” means in practice, and how to practice a straight pull.
What the pull-through does
The pull-through has three jobs:
- It carries the disc along the line you set during the reach-back.
- It keeps the disc close to your body as it enters the power pocket.
- It sets up the release point, which controls the disc’s angle and spin.
If the pull does those three things, the release has a good chance of starting in the right place. If it doesn’t, no amount of arm speed fixes the flight.
Hips first, arm second
The order of movement matters more than any single position. In a good backhand, the sequence runs from the plant to the hips, then the torso, then the elbow, then the arm and hand, and finally the release.
An all-arm throw breaks that order. The arm starts pulling before the hips have turned, so the throw relies on the shoulder and arm. It tends to be tense, slower to repeat, and harder on the elbow and shoulder. Many players who feel they “throw hard” are actually throwing with the arm alone.
Hip rotation should feel like a turn that begins after the front foot plants. The back foot pivots, the hips open toward the target, and the chest follows. Keep the turn controlled. If the body spins past the target too early, the disc is pulled off line. That is a separate problem from a late hip turn, and it is covered in the throwing problems guide.
Elbow up and the elbow lead
“Elbow up” is used in different ways. Here it means keeping the elbow high and in front of the disc during the pull, rather than letting it drop behind or flare out to the side. The elbow leads the pull, and the hand follows.
Many coaches connect an elbow-led pull with a nose-down release. When the hand leads, the disc tends to tip its front edge up. When the elbow leads and the hand follows, the front edge is more likely to stay level or slightly down.
Two common errors show up here:
- Elbow drop: the elbow sinks as the disc comes into the power pocket. The pull becomes flat and loses line.
- Elbow flare: the elbow shoots out to the side. The disc swings wide and the release point moves around.
Keeping the pull straight
The straight pull starts with the reach-back. The disc travels back along the target line, then comes through the power pocket close to your chest. If the reach-back is a wide arc, the pull has to fix the arc, and it usually doesn’t. Reaching straight back is the first step, and our pillar guide covers the reach-back in more detail.
A useful picture: your throwing elbow and the disc should travel along the same imaginary line from the reach-back through the chest. If the disc is ahead of or behind that line, the pull is off.
Drills
Each drill has one clear check. Run them slowly before adding speed.
- Wall drill. Set a wall or fence along your throwing side. Pull the disc through in slow motion without letting it touch the wall. If it swings away, you are rounding.
- Power-pocket pause. Throw a standstill backhand, then freeze at the power pocket for two seconds. Check that the disc is close to your chest and the elbow is up and in front. Then finish the throw.
- Hip-first drill. Hold the disc at chest height with your elbow bent. Turn your hips toward the target, then extend the arm slowly. Repeat ten times at a walking pace.
- Cone drill. Place a cone about three feet in front of your power pocket on the target line. Pull the disc past the cone at chest height without touching it.
The backhand drills article has more timing and accuracy drills you can run in the same sessions.
Common errors
- The hand leads and the elbow follows, which tends to produce a nose-up release
- The elbow drops early and the pull goes flat
- The reach-back wraps around the body
- The hips open too early, so the shoulders spin past the target
- The arm locks straight at release and the disc loses snap
Checking your pull on video
Film from two angles. From the side, check the elbow height at the power pocket and whether the hips are turning before the arm starts. From behind, check whether the disc travels along the target line from the reach-back through the chest.
Compare your footage with an experienced player’s slow-motion video. The biggest differences usually show up in the first half of the pull, not in the release. For the release itself, see the release and spin guide.