Shot Types

How to Throw an Anhyzer in Disc Golf

How to throw an anhyzer in disc golf: the release angle that turns a disc right first, when to use it, how to set up, and how to follow through.

On this page
  1. What an anhyzer is
  2. Why throw an anhyzer
  3. Setting up
  4. Releasing the disc
  5. Following through
  6. Choosing the disc
  7. Wind
  8. Practicing in the field
  9. Common mistakes

What an anhyzer is

An anhyzer is a release angle. For a right-handed backhand, the disc leaves your hand with its left edge higher than its right edge, so the right edge is tilted down. The disc tends to turn right early in its flight, then fade back left. Many players call it an “anny.”

The opposite release is the hyzer, where the left edge is lower. Left-handed players use the mirror image of both.

Why throw an anhyzer

An anhyzer is useful when you want the disc to bend right on purpose:

  • Right-turning holes. A turnover, which is an anhyzer that turns right and holds, can follow a dogleg right.
  • Tailwinds. A tailwind can help keep the disc on its planned path.
  • Flex shots. An overstable disc thrown on an anhyzer turns right, then fights back left in an S-shaped flight.
  • Rollers. An anhyzer release helps some rolling shots land on their edge.

Setting up

Your stance matters less than your aim. Because the disc turns right, aim where the disc will start its turn, not at the basket. For a dogleg right, aim left of the target so that the disc bends into the basket.

Some players lean back a little to set their spine and shoulders on the anhyzer plane. Use that cue only if it helps you. Check the result in a field before you rely on it in a round.

Releasing the disc

Keep the disc on the plane of your forearm. Tilting only the wrist to make the angle is the most common error, and it causes the disc to dive or flip. If you need more angle, raise the wrist slightly as a whole, rather than bending it sideways.

Pull through in a smooth arc. A flat chopping motion tends to drop the disc too early. Let your forearm extend naturally through the release.

Following through

Finish the throw through the same plane you released it on. If you stop the arm early, the disc tends to pop its nose up and crash out of the air before it reaches its turn. Hold the follow-through until your hand points where you want the disc to go.

Choosing the disc

For a clean anhyzer that holds its angle, use a neutral or understable fairway driver or mid-range. These discs turn right and stay there. An overstable disc on the same angle will turn right, then fight back left, which gives you the flex shot instead. Know which result you want before you pick a disc.

Wind

A tailwind helps the disc hold its angle and finish its fade. A headwind can make an anhyzer turn too hard and dive into the ground. If the wind is coming straight at you, reduce the angle or pick a more stable disc, and test the shot in the field first.

Practicing in the field

Pick one disc and throw it three ways: flat, with a slight anhyzer, and with a steeper anhyzer. Mark each landing spot. Then compare the flights and note where the disc starts turning. Do the same with a hyzer. Seeing the two side by side is the fastest way to learn how the angle changes the shot.

Place a stick or a second disc on the ground as a start line. Keep your feet and hips in the same place for each throw, so that only the release angle changes.

Common mistakes

  • Tilting the wrist instead of the disc plane, which makes the release inconsistent.
  • Aiming at the basket, which leaves the disc to the right of the target.
  • Stopping the follow-through early, which lifts the nose.
  • Too much angle on a fast disc, which turns it over hard.

Once the anhyzer is reliable, the turnover guide applies it to a real right-turning shot. The understable and overstable guide explains which discs hold the angle and which will flex.

The complete guide to shot types

Disc Golf Throws Explained: Every Shot Type
Read the guide

Keep exploring

Guides from other topics

All topics →