Shot Types

How to Throw a Backhand Roller in Disc Golf

How to throw a backhand roller in disc golf: the steep release, disc choice, reading the ground and wind, and the mistakes that send the disc into the dirt.

On this page
  1. What a backhand roller is
  2. When a backhand roller helps
  3. How it differs from a normal backhand
  4. Choosing a disc
  5. Setup and release
  6. Reading the ground
  7. Wind
  8. Common mistakes
  9. A practice plan

What a backhand roller is

A roller is a throw that lands on its edge and rolls along the ground instead of flying. The backhand roller uses the same reach-back, hip-first motion as a normal backhand, but the disc leaves your hand on a steep angle. It tips over during its short time in the air and lands on its rim, then rolls.

Rollers are useful when an air shot would hit branches or when a long, firm fairway lets the disc run. They can cover a lot of ground with little height. They are also less predictable than a flying shot, so they are best practiced before you rely on them in a round.

When a backhand roller helps

  • Under a low ceiling of branches, where a high shot would be blocked.
  • On a long open fairway with short, firm grass or hard-packed dirt.
  • When you need distance, and the landing area lets the disc keep rolling.

How it differs from a normal backhand

A standard backhand is released with the disc flying. A backhand roller is released steeply and usually with an understable fairway driver or mid-range disc, because that disc is more likely to flip over during its brief flight. A stable or overstable disc tends to stay flat and fly rather than roll.

Many right-handed players throw a backhand roller that cuts left as it lands. The angle you release on sets how hard it cuts.

Choosing a disc

An understable fairway driver or mid-range is the usual choice, since it flips more readily. A more stable disc is harder to turn over, so it may fly instead of rolling. Test a few discs at the same angle and power to see which one rolls the way you want.

Setup and release

Set up as you would for a backhand, with a neutral stance and your hips ready to open. Reach back, keep the disc low, and pull through with the release angle you have chosen. The disc should leave your hand on the tilt you planned, without a late wrist change.

Follow through along the same plane as the release. Stopping the arm early tends to let the disc nose up, which costs ground and can send it into the air instead of onto the edge.

Reading the ground

The best surface is smooth, short grass or hard-packed dirt. Roots, rocks and tall, wet grass can grab the rim and knock the disc off line. Uphill slopes slow the roll and can stall it. Downhill slopes speed it up. Walk the landing zone before you throw, and pick a line that stays clear of obstacles.

Wind

Wind changes when the disc flips and how far it rolls. A headwind can make the disc turn over earlier, and a crosswind can push it off its line. Calm air or a light tailwind usually gives the cleanest roll. If the wind is strong, choose a different shot.

Common mistakes

  • Too steep: the disc flips too early and dives into the ground.
  • Too shallow: the disc skips or floats and never settles onto its edge.
  • Nose up at release: the disc climbs and loses ground.
  • Off-line follow-through: the arm drifts away from the line, and the disc follows it.

A practice plan

Start on flat ground with short throws. Change one thing at a time: first the release angle, then the power, then the disc. Keep a short log of what you threw and where the disc rolled. After a few sessions, you will know which angle and disc produce the roll you want.

When you are comfortable with the backhand version, the forehand roller guide shows the same goal from the sidearm side. The anhyzer guide explains how angle changes the flight for a shot that does not roll.

The complete guide to shot types

Disc Golf Throws Explained: Every Shot Type
Read the guide

Keep exploring

Guides from other topics

All topics →